Introduction: BTS - Mouth off Nerdy to Me Submarine

Materials:

  • 12 pieces of 6-inch pvc pipe
  • 2 pieces of 3-inch PVC pipe
  • 1 piece of 18-inch pvc pipe
  • 8 three way elbows
  • 1 t-elbow
  • 3, 2 feet wire
  • 3 switches
  • 3 engines
  • 3 propellers
  • 1 power supply

Step 1: Step 1: Construction the Base

To build the base you will need 4 three-path elbows and 4 of the 11 pieces of 6-inch PVC pipe. To start you need to get one three-means elbow and peerless 6-inch pvc shrill. You will stick one end of the tabor pipe into the three-way human elbow. one time you fare that put the other triangular elbow on the other end of the 6-inch premature ventricular contraction pipe, you will repeat this 3 many multiplication.

Follow the movie if necessary

Step 2: Step 2: Construction the Sides

To build the sides you will need to get 4 6-edge in pvc pipes, next you leave put forward each one of them in the top of from each one three-way elbows.

Follow the picture if needed

Stride 3: Tread 3: Attaching Three Style Elbows to the Tipto

To confiscate 4 of the 3-way elbows you will need to put the three-way elbows on crowning of the 4 pipes that are already placed.

Trace the picture if needed

Step 4: Step 4: Attaching the Pvc Pipe to the Three-room Elbows

To complete the upper side you will need to only get three of the 10-inch pvc pipes. you will impound three of the soh there is only one space left to fulfill in.

Comply the picture if needed

Step 5: Step 5: Attaching the Two 3-column inch Pvc Pipes

You will need single triplet-way elbow and two 3-inch premature ventricular contraction pipes, then you wish connect the triangular elbow to both ends of the ii 3-in pvc pipe.

Follow the picture if needed

Step 6: Stride 6: Fill in the Space

With the piece you made in step 5 you will pauperism to connect that piece with the two tripartite elbows.

Keep an eye on the picture if needed

Step 7: Step 7: Attaching the Pilfer

You will penury the 18-inch premature ventricular contraction pipe with that you volition need to connect that to the human elbow on the slope.

Follow the picture if needed

Step 8: Stone's throw 8: Attaching the Motors

To attach the iii motors you bequeath need 6 zip ties and electrical tape. Erst you have that attach the side motors with the zip ties in a interbreeding pattern only two zip ties are requisite per motor angle the two slope motors at 80 degrees. The hindermost motor wish face 180 degrees on an x-axis. once the motors are in put over fasten them by tape recording them with electrical tape.

Step 9: Pace 9: Bonding Your Wires

Now you cut some insulation the size of the pipe and cut it so you can put it around the pvc. Tapeline it all around so it stays in topographic point.

Step 10: Soldering Wires and Connecting World power Supply

You now connect the motors to the long wire you have red goes to one efferent, green to some other, and brown to the fourth-year one. Connected the other end of the wire you connect the switches and power supply. Solder complete of the wires together let information technology harden and then cover them with physical phenomenon tape.

Step 11: Making the Remote

Take a little patch of plywood and screw three holes for your switches, this will be the unlikely. Glue the switches in place and let dry.

Be the First to Share

Recommendations

  • Anything Goes Contend 2022

    Anything Goes Contest 2022